Experiment 8 - Amide Preparation

Objective

In this experiment, the amide, 2-(N-acetylamino)benzoic acid (N-Acetylanthranilic acid) will be prepared by the reaction of 2-aminobenzoic acid (anthranilic acid) with acetic anhydride.

Introduction

Amides are another one of the many functional groups encountered in the study of Organic Chemistry. The amide is identified by having a carbonyl unit (C=O) bound to a Nitrogen unit (NR₂, R can be H).

Figure 1

An amide can be produced in a variety of ways: 1) From the reaction of an acyl halide with a 1° or 2° amine, 2) the reaction of a carboxylic acid with an amine (usually requires heating), and 3) the reaction of an acid anhydride (commonly acetic anhydride) with an amine.

Figure 2

The amide linkage is seen in Biochemical examples where amino acids condense together to form peptides and proteins. The peptide bond is an example of an amide linkage.

Figure 3

Pre-Lab

Complete the pre-lab assignment in WebAssign.

Procedure

Note: Make sure that the reaction is performed under the bench hoods (i.e., not out in the middle of the bench top). Acetic anhydride is a lachrymator (look up what this means).

Place 1 g of anthranilic acid and 3-4 mL of acetic anhydride in a 25 mL Erlenmeyer flask.

Warm the mixture to boiling (gently) on a hot plate set to 260°C. All solid should dissolve.

Heat for a period of 15 minutes.

Allow to cool to room temperature.

Add 2 mL of water to the mixture.

Heat the mixture to boiling again.

Slowly let the reaction mixture cool to room temperature (i.e., no ice bath or cold tap water) so that the solid formed will have larger crystals.

Isolate the product by vacuum filtration (here is a video that shows you how to do a vacuum filtration).

Wash with a small amount of cold water while still on the Buchner funnel.

Determine the yield, percentage yield, and melting point of the product. Here is a video that shows you how to take a melting point.

Waste Disposal

The filtrate should be placed in a beaker designated by your TA to be neutralized.

Any solid product should be added to the "SOLID WASTE" container.

Melting point capillaries and test tubes should be thrown in broken glass.

In-Lab Questions

Download and print the following worksheet. You will use this worksheet to record your answers to the In-Lab questions.

Questions

Record the following data.

Question 1: Amount of anthranilic acid used ___________________ g, ___________________ mol
Question 2: Theoretical Yield of product _____________________
Question 3: Actual Yield of product _____________________
Question 4: Percentage Yield _____________________
Question 5: Melting Point ___________________ (observed), ___________________ (actual)
Question 6: Record your calculations.